Skip to main content

Models

Add Models​

Start by clicking in Lists / Models view.

Select or create a new manufacturer.

After selecting the manufacturer, fill in the model details.

Provide a name for the model (max 80 characters) and an optional description (4000 characters) and a note.

  • If you are adding a reference device model (instrument that is going to be used as a calibrator), toggle Show in references on. That allows the model to be selectable when creating a reference, and
  • if you are adding a Custom RTD sensor model, also enable Custom RTD sensor. This allows you to enter the sensor specific coefficients (Cvd or ITS-90) when creating a sensor.

Model

About Custom RTD sensors​

Custom RTD sensors refer to temperature sensors, usually reference sensors, whose individual temperature / resistance relationship has been established during the calibration of the sensor.

There are several equations and coefficients to calculate the sensor's resistance to temperature. LOGiCAL supports the following equations:

  • Callendar-van Dusen
  • ITS-90
  • Factor

The use of the coefficients will correct the sensor measurement and will make it measure very accurately.

Edit Models​

Editing is started by selecting a quantity and clicking . This opens the edit sidebar.

Model_Edit

Note!

  • Pre-populated models cannot be edited, as they are maintained by Beamex.

Remove Models​

Start by selecting one or multiple models and clicking in Lists / Models view.

Note!

  • Pre-populated models cannot be removed, as they are maintained by Beamex.